All Stationeers mods

Growlights Control By Name

Building & decoration · Steam Workshop

Instructions: * Place the IC and turn it on (no need to configure pins or anything) * Group the plants that have the same light/dark requirements together and build a growlight above them * Name the growlight with the name based on how much light/dark the

IC night lights

Building & decoration · Steam Workshop

Simple IC control of Wall Lights for Day/Night operations. Only needs IC chip, IC housing, Sensor​

Heating and Cooling Room IC

Building & decoration · Steam Workshop

2 Wall coolers, 2 Wall heaters, Gas Sensor, Ic and IC Chip. Batch Writer can be added to support more heaters and coolers​. Uses setpoints of 20 and 25 C for Cooling Uses setpoints 17 and 23 C for Heating. Only 1 Chip is needed to run this for a small room

Universal 2 or 3-Door Airlock (Screwed Edition)

Building & decoration · Steam Workshop

The Direct Upgrade for the Advanced Airlock Circuit Board. Screwed Edition - No labeler needed, one vent per door. This one will stay up for those who don't want to rename things. Mass-vent Edition Found here: https://steamcommunity.com/sharedfiles/filedet

Greenhouse Temp

Building & decoration · Steam Workshop

Wall Cooler and Wall Heater Manager​

Total-Atmo-Control

Building & decoration · Steam Workshop

A simple but effective atmospheric controller mixing Oxygen, Nitrogen, and bit of Carbon-Dioxide if you have plants in the same space. also controls temperature via Wall Heater/Cooler, and adjusts pressure to 102 Kpa. Important to note that not all of the

Fully Automatic Advanced Furnace

Building & decoration · Steam Workshop

Survival Ready and Easy to Build.

Windy Skunk's Hot Room Design

Building & decoration · Steam Workshop

Created 8.7.2018 The hot room is designed to capture waste heat from the furnace for use elsewhere. From rough calculations, it appears to make heating cost 10% of what it would cost using wall heaters. This save contains: A fully functional hot room A sec

Automated Doors with Proximity Sensor

Building & decoration · Steam Workshop

Set Sensor to d0, then door you want to automate to d1. you can extend the distance setting by changing the "s sensor Setting 3" to a larger number.​

AirLock

Building & decoration · Steam Workshop

Hello about the code. 1. Connect the gas sensor to (Gas) It remembers where and how much pressure was. 2. Connect the door of the entrance to the room to (DoorI) 3. Connect the exit door to (DoorO) 4 Entrance ventilation, the one that leads to the room (Ve

Fire (Door & Estinguisher System)

Building & decoration · Steam Workshop

Simple Auto Closing Door

Building & decoration · Steam Workshop

Automatically closes your door after a 10 tick delay.​ Needed: 1x IC Housing. 1x IC10 Chip. 1x Door. 1x LogicSwitch. (optional) 1x LCDDisplay. (optional) and obviously 1x computer with ICeditor motherboard to write the chip. How To: Link your door to Devic